Firstgens.com

What would you think a 12 bolt rear end out of a 72 chevelle would be worth?
It has leaf spring perches welded to it to fit in a 69 camaro with leafs but could be cut off for a chevelle. Otherwise it could be reused in a camaro is someone needed it.
5:13 gears and limited slip that I will probably have to open up to see exactly what it is. Drum brakes...etc.

On housing:
B112 = February 11 1972
Bottom drivers side stamp
3969278NF
http://www.myss396.com/ChevelleInfo/Dif ... tials.html
3" tubes taper to 2 5/8" at ends
11 1/2" drums

backing plate to backing plate is about 54" width

ttt.....

well if it hasnt been narrowed it will be wider than a camaro 12 bolt and with 5:13`s it will be a hard sell!!
if it has the coil spring perches still on it , grind off the leaf spring perches and swap the gears to a 4:10 or smaller and i would guess you could fetch 1000 or more?
i paid 1400 for my 12 bolt for my 71 chevelle with all new guts(eaton) and axles and 3:73`s

I have to admit, it fits under a camaro really well. And from the dimensions as shown, it doesn't appear to me to have been shortened.
And I have 15x7s on it too and they tuck up in the wheel well.
I'm not going to swap buy and swap parts just to sell it.
When I pull it out, I will probably just craigslist it or fleabay it.