Shipped my Strange housing, Daytona pinion support and 1350 yoke to Moser a week ago Friday for them to install a new WaveTrac unit and new Motive 3.89 gears and this is what I got back exactly 1 week to the day later...............
Attachment:
IMG_0748.jpg [ 47.31 KiB | Viewed 585 times ]
Attachment:
IMG_0749.jpg [ 56.04 KiB | Viewed 585 times ]
Pressed the new bearings and retainer sleeves onto the axles today. These bearings have an o-ring on the OD that seals to the ID of the housing end. In addition I opted to use the inner axle seals that go into the housing ends before that axles go in. Hopefully the double seal arrangement(prolly overkill) will cure the leaks I was plagued with on both axles in the past.
Attachment:
IMG_0776.jpg [ 48 KiB | Viewed 585 times ]
Attachment:
IMG_0777.jpg [ 67.36 KiB | Viewed 585 times ]
Although this posi unit was significantly more expensive that others out in the market there were several reasons I chose it.........
1. It was the only posi available for a 9" Ford rear that would accept the 35 spline axles I already had.
2. It has a horspower rating of 1000hp. Frank at Prodigy Customs is currently testing one behind 1300hp in a drag car.
3. Completly American made
4. Has a Lifetime and transferable warranty
5. I had grown very tired of the noise and unpredictablility from the Detroit Locker which by the way is for sale. Also have a set of 4:30 and 3:70 9" gears for sale too.
Login
Register
FAQ
Search
